Starrett SR100 Surface Roughness Tester

 

                             

 EASY-TO-USE & ACCURATE

The SR100 portable surface roughness tester is powerful, accurate and easy to use.

 With the SR100, you can measure roughness almost anywhere. It is ideal for checking large components, structures, auditing batch production prior to shipment and production line process control.                                                                               

Separates into Two Pieces

The innovative SR100 separates into two pieces to measure surface roughness. The bottom half contains the traverse mechanism and stylus pick up assembly. This is placed on the surface to be measured. It has a wide base to ensure stability.

The upper half includes the large LCD display, start button, mode and parameter buttons, comfortably  hand held for easy operation and clear viewing.

How it does it                    

A diamond stylus is drawn across the part. The motorized traverse mechanism is cam driven to ensure that the correct horizontal distance is traveled.

Vertical movement of the stylus as it travels across peaks and valleys is detected by a piezo-electric pick up which converts mechanical movement into an electrical signal.

The electrical signal is digitized and sent to a microprocessor where the parameters are instantly calculated using standardized algorithms.

                                             

Features

*Large LCD window

 

*Measures Ra at the touch of a button

 

*In addition to basic roughness parameter Ra and Rz, also measures advanced Rp, Rv, and Rt parameters

 

*five second cycle time

 

*Result saved until the next measurement is taken

 

*Switches between inch and metric mode without remeasuring

 

*Use right out of the box-little or no operator training required

 

*Automatic shut-off after five minutes of inactivity

 

*Configured with the most common industrial settings to ensure correlation between multiple operators (see specifications)

 

*Simple and reliable calibration routine

 

*Uses standard off-the shelf calculator type batteries with a minimum life of 5,000 measurements

 

*Includes SR100 two-piece assembly, calibration standard, batteries, operation guide and a carrying case

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

                

 

                     

 

SR100 Surface Roughness Tester & Accessories

Cat. No.              EDP

SR100                 20950    SR100 two-piece surface roughness tester assembly,

                                     calibration standard, batteries, operation guide and a

                                     carrying case.

         

Rapp Industrial Sales * 127 Main Street * Connoquenessing, Pa 16027

Phone 888-789-7277 * 724-789-7853 * Fax 724-789-7288 Email: sales @rappindustrialsales.com